NHT Case Depth Calculation and Optimizer
 |
|
FEATURES
NHT software module is a software run in Windows PC. It calculates heat treating time from inputs of kind of steel, nitriding temperature and desired case depth. This software contains a data-base which covers most kinds of steels available in market.
Result of the calculation is displayed in a graphic and shows target time for your requirement with a marker. With this on-line use, after you manipulate heat treatment parameters as much as you want until optimization is achieved, the result can be transferred to any of Stange SE6XX controllers on local control panels. The on-line use displays hardness underway at local furnace on the graphic with another marker. This online usage enables you to know what the process going on and what you desire on the treatment. Should any irregular circumstances are recognized, you can update the new control parameters derived form this software in order to revive the process.
NHT software used together with Stange NKZ nitriding potential calculation software gives you a set of control set-points, such as heat treatment time and nitriding, oxygen and carburizing potential.
Features:
- Calculation based on nitriding temperature.
- Hardness trend expression, by nitriding depth versus time.
- Trend bar expression of thickness of compound layer and surface harness.
SPECIFICATION
【INPUTS/SELECTION】
- KIND of STEELS (24)
16MnCr5, 20MnCr5, 25CrMo4, 30CrMoV9, 30WCrV17-2, 31CrMoV9, 32CrMo12, 34CrAl6, 34CrAlMo5, 34CrAlNi7, 42CrMo4, 42CrMoS4, 43CrMo4, 51CrV4, 56NiCrMoV7, 58CrV4, C10,
- REQUIREMENTS of HEAT TREATMENT
Temperarture, Nitriding Case Depth and Nitriding potential（Kn）
【HOW TO USE】
- Inputs all conditions and set-points
NOTE: Parameters and set-points to be input may vary with which method you selected.
- Push "Calculation" button
Calculation is updated with the new data.
【RESULT of CALCULATION】
- Parameters to Be Simulated
Nitriding Case Depth mm, Thickness of Compound Layer % Case Hardness %
- Graphic Expression
Nitriding Case Depth mm, Nitriding time, Marker(s)
| OFF-Line Mode | ON-Line Mode |
 |
 |
※For:Southeast Aisia East Aisia & Oceania Regions